Although most feel plump and smooth skin immediately after a session, you must allow at least 6 weeks to see noticeable results. It’s during the first 6 to 8 weeks of concentrated use that your collagen and elastin gradually rebuild and strengthen, to tighten and rejuvenate your skin. This is a smarter, more responsive temperature sensor which continuously reads your skin temperature and adapts the RF power as it’s needed. This is good because you have different types and depths of tissue all around your face. The sensor gives a more even and accurate RF delivery around your different facial contours. Next move the device in an upward linear motion along your jawline contour, starting right below your chin. You can switch to the blue DMA + RF mode for this step only. Repeat 10-20 times. The RF mode feels like a warm sensation on the skin, though if you’re sensitive to heat you might find it uncomfortable. I actually find it relaxing! But the DMA mode will hurt – like someone snapping rubber bands constantly on your skin. As you go from low to high mode the heat/pain will increase as well. Now the STOP RF doesn’t help prevent or clear blemishes as other devices can. And since quitting microcurrent my spots and under-the-surface bumps have returned. And especially those pesky reoccurring hormonal zits. They spoil my otherwise healthy complexion so at week six I decide to treat myself to a Tripollar Geneo facial.

The Tripollar STOP Balm is suitable for 12-15 full course treatments depending on how much gel is applied during treatment. For those who don’t know who TriPollar are, they’re one of the biggest anti-ageing brands in the world. Radio frequency was a technology that was previously used in salons, TriPollar have created devices for both the face and body that allow you to create professional level aesthetic results at home. Most famous for their radio frequency devices such as the TriPollar STOP (for the face) and TriPollar POSE (for the body), the brand have harnessed the same technology in the all-new pint-sized TriPollar STOP Eye device. TriPollar Stop Eye 2+ skin rejuvenation device is a non-invasive home treatment, for delicate facial areas, such as around the eyes and mouth.The Stop Eye 2+ is specifically intended for skin tightening in the periorbital, Perioral and Nasolabial folds. This clinically-proven, safe, relaxing and easy-to-operate skin-tightening device, improves the skin’s texture, giving you a fresh, younger look.For optimal results, use your Tripollar Stop Eye device 2-3 times a week for a period of 6-8 weeks. The device has two intesnity levels, just like the TriPollar STOP, and you’ll need to use it with the TriPollar Preparation Balm. Specifically formulated to be used on delicate skin with the TriPollar STOP Eye Renewal Device, it optimises your treatment by effectively conducting the Radio Frequency power through to the deeper levels of the skin. I hope the STOP will maintain my healthy, supple, smooth, bright and hydrated skin. I’d like to maintain my small pores too. I’m really hoping the STOP can tighten and lift my small jowls and under-chin sag, smooth my under-eye area, and perhaps reduce my forehead lines a bit more. The Stop Eye 2+ harnesses TriPollar RF technology. During the treatment, the energy generated by the device is directed towards the skin’s tissue and the ECM (extra-cellular matrix), whereby these layers are heated moderately. Patients experience a warm, relaxing sensation on the skin’s surface, while a therapeutic action is occurring deep within the skin. The localized heating causes an immediate contraction of the collagen fibers in the dermis, forcing them to contract, while also increasing fibroblast activity.As a result, regeneration of new collagen and elastin fibers is induced. The contraction of collagen fibers and the regeneration of the collagen and elastin tighten the skin, creating smoother, healthier and younger looking skin, visible after the first treatment.

For a week by week breakdown, I recommend reading my Stop X review as the results are very similar. As my nasolabial folds are is where I have the most noticeable sagging skin, I saw noticeable lifting and plumping at around the 8-week mark. In terms of plumpness and firmness I’m pretty much maintaining my results from before. Each treatment should take around 4 minutes, meaning you can easily fit it in to a morning or night time routine. We do not recommend use of our devices if you have an impaired immune system due to immunosuppressive medications or immunosuppressive diseases such as AIDS.These skin reactions gradually fade a few hours after the session. But the next morning my skin feels exceptionally smooth and soft. Schedule, effort & results It demands commitment to start, but maintenance is easy. The device uses RF technology to tighten the skin in these specific areas, increasing the production of collagen and creating smoother, healthier and younger looking skin, visible after the first treatment. Much like laser and LED treatments, radio frequency is a non-surgical way of tightening and firming the skin. A popular anti-ageing solution, it gives off heat energy which works below the surface of the skin to stimulate collagen and elastin production. It works by heating the dermis (the lower layers of the skin) and tightens it without damaging the top layer. Multi-RF means more than one frequency of RF current flows into your skin. The frequencies travel to and create heat at different depths in your dermis. So, it’s much more thorough and faster at heating your skin. It also stimulates more fibroblasts so you get extra collagen and elastin. In short, it promises stronger and longer-lasting results.